Which material should I choose?
Tell us where the part will live. A dashboard part in the sun needs a different plastic from a toy on a shelf. Every material costs the same per gram, so choose by what the part needs.
| Material | Heat resistance | Strength | Flexible | Best for |
|---|
Common situations
A part inside my car
Use ASA or ABS. A car parked in the sun gets hot enough to bend PLA, so louvres, clips, knobs and anything on the dashboard should be ASA/ABS.
RC car parts
PETG for gears, posts and mounts, because it is tough and doesn't snap easily. TPU for tyres and bumpers, because it is rubbery.
A toy, figure, statue or gift
PLA. It gives the sharpest detail and the widest choice of colours, including silk gold and silver.
Something that lives outdoors
PETG or ASA. Both handle sun and rain far better than PLA.
What does "infill" mean?
3D prints are hollow inside with a honeycomb pattern. Infill is how full that inside is. 15 to 20% is fine for display pieces; 40 to 60% for parts that take force; 100% for small parts that must not break.
What layer height should I pick?
Smaller layers look smoother but take longer. Standard 0.20 mm suits most parts. Use Fine 0.12 mm or Ultra 0.08 mm for faces and figures.